Worked examples to EC3 quiz

Please answer the following 10 multiple choice questions, then click 'submit' to check the result. The pass mark for a CPD certificate is 8 out of 10, and you may retake the quiz as many times as you wish, but the questions will vary! Please note that one, two, three or all of the possible answers presented for each question may be right, and to gain a mark for that question all correct answers must be identified.

Good luck

Worked examples to EC3

Which combination of checks are required for elements in tension?

Gross area using yield strength, and γM0
Gross area using yield strength, and γM1
Net area using yield strength, and γM1
Net area using ultimate strength and γM2

Having calculated the non-dimensional slenderness, how might the reduction factor, χ, be determined?

Using the expressions given in EN 1993
Using the figure given in EN 1993
Using look-up tables in NCCI
Using look-up tables in EN 1993

Where does a designer find values of C1 for different shapes of bending moment diagram?

In BS EN 1993-1-1
In the UK National Annex to BS EN 1993-1-1
In NCCI
In an appendix to BS EN 1993-1-1

What value of ξ is specified in the UK National Annex?

The recommended value of 0.85
0.925
0.950
0.875

How is ε calculated?

No need - its given in the tables
ε = (235/fy)1/2
ε = (275/fy)1/2
ε = (355/fy)1/2

Which partial factor should be used when calculating buckling resistance?

γM0
γM1
γM2
It depends on the mode of buckling

When designing, which country's National Annex should be used?

No NA is needed if the recommended values are chosen
The NA for the country where design is carried out
The NA for the country where construction is to be carried out
The choice of NA should be specified by the client

For designs to be constructed in the UK, where should the steel strength be taken from?

The designer may choose
The UK National Annex to BS EN 1993-1-1
The product Standard
BS EN 1993-1-1

When calculating the cross-sectional resistance of a member, what is the value of the partial factor, γM0 specified in the UK National Annex?

1.0
1.05
1.1
1.15

What structural mechanics is allowed for in the C1 factor when calculating Mcr?

The influence of the axial load
The influence of residual stresses
The shape of the bending moment diagram
Initial imperfections in the member