Sustainability and steel construction quiz

Please answer the following 10 multiple choice questions, then click 'submit' to check the result. The pass mark for a CPD certificate is 8 out of 10, and you may retake the quiz as many times as you wish, but the questions will vary! Please note that one, two, three or all of the possible answers presented for each question may be right, and to gain a mark for that question all correct answers must be identified.

Good luck

Sustainability and steel construction

Which of these initiatives is NOT targeted at the reduction of operational carbon emissions from buildings?

Energy Performance Certificates
The Aggregates Tax
The Green Deal
The Renewable Heat Incentive

Of these following common construction materials, which has the best end-of-life recycling credentials?

Concrete
Steel
Timber
They are all the same

When assessing the environmental impact of buildings or construction products, what scope of assessment should be used to obtain the most accurate results?

Cradle to gate
Cradle to grave
Cradle to gate with options
It makes no difference

Under BREEAM 2011, what overall score is required to achieve an ‘Excellent’ rating?

45%
55%
70%
85%

In the Green Guide to Specification (4th ed) which of the following commercial and industrial upper floor specifications has the highest rating?

Power floated in-situ reinforced concrete floor slab
Power floated post-tensioned in-situ reinforced concrete floor slab
Power floated in-situ reinforced concrete slab on ‘deep’ profiled metal decking
Power floated in-situ reinforced concrete slab on ‘shallow’ profiled metal decking

New, non-domestic buildings in the UK will need to be ‘zero carbon’ in operation by?

2013
2016
2019
2050

Which phase of the building life cycle is currently responsible for the greatest proportion of carbon emissions?

Design
Construction
In-use
Demolition

In buildings designed to take advantage of thermal mass, what is the optimum depth of concrete upper floor slabs?

50mm
90mm
150mm
200mm

Which of these are sustainability credentials of structural steel?

High structural efficiency
Offsite construction
Low waste
Infinitely recyclable

In England and Wales, which Approved Document is applicable to the operational energy/carbon performance new build, non-domestic buildings?

Approved Document L1A
Approved Document L1B
Approved Document L2A
Approved Document L2B