Corrosion protection quiz

From SteelConstruction.info
Revision as of 12:11, 12 March 2019 by Chris.dolling@steelconstruction.org (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Please answer the following 10 multiple choice questions, then click 'submit' to check the result. The pass mark for a CPD certificate is 8 out of 10, and you may retake the quiz as many times as you wish, but the questions will vary! Please note that one, two, three or all of the possible answers presented for each question may be right, and to gain a mark for that question all correct answers must be identified.

Good luck

Corrosion protection

In which 'Corrosivity Category' can steel be used without corrosion protection?

C1
C2
C3
C4

Identify one of the main requirements of a prefabrication primer?

To be 'weldable'
To provide long term protection
To be a thick coating
To dry slowly

When is acid pickling carried out?

Before coating small components
As a pre-treatment for painting
Before hot dip galvanizing
Never

Which of the following can be found in a corrosion protection specification?

How to mix paints
Coating film thicknesses
Types of coating equipment
Method of surface preparation

When should coating inspection be carried out?

After the job is completed
Only when painting is being carried out
Throughout the whole job
Only for special structures

UHP water jetting is used to?

Create a surface profile
Remove paint
Remove soluble salts
Clean a paint coating

What are surface profile comparators used for?

To check the smoothness of a paint coating
To grade the roughness of a thermally sprayed coating
To grade the roughness of a blast cleaned steel surface
To check the standard of cleanliness of blast cleaned steel

What is the most common form of corrosion protection?

Hot dip galvanizing
Paint coatings
Thermally sprayed metal coatings
Paint and metal coatings together

Which standard refers to 'the treatment of welds, edges and other surface imperfections'?

BS 7079
ISO 8501-3
BS EN ISO 8504-3
BS EN ISO 8503-5

How many photographic 'rust grades' are there in BS EN ISO 8501-1?

2
3
4
None