Corrosion protection quiz

From SteelConstruction.info
Revision as of 12:11, 12 March 2019 by Chris.dolling@steelconstruction.org (talk | contribs) (Created page with "Please answer the following 10 multiple choice questions, then click 'submit' to check the result. The pass mark for a CPD certificate is 8 out of 10, and you may retake the quiz...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Please answer the following 10 multiple choice questions, then click 'submit' to check the result. The pass mark for a CPD certificate is 8 out of 10, and you may retake the quiz as many times as you wish, but the questions will vary! Please note that one, two, three or all of the possible answers presented for each question may be right, and to gain a mark for that question all correct answers must be identified.

Good luck

Corrosion protection

What type of surface 'roughness' should steel have before being thermally metal sprayed?

Rounded with high profile amplitude
Angular with high profile amplitude
Rounded with low profile amplitude
Angular with low profile amplitude

The key to successful corrosion protection should consider which of the following?

Good design detailing of the structure
The corrosivity of the environment
The type of steel used
A good coating specification

When is acid pickling carried out?

Before coating small components
As a pre-treatment for painting
Before hot dip galvanizing
Never

Identify one of the main requirements of a prefabrication primer?

To be 'weldable'
To provide long term protection
To be a thick coating
To dry slowly

UHP water jetting is used to?

Create a surface profile
Remove paint
Remove soluble salts
Clean a paint coating

Which of the following organisations have 'prescriptive' specifications for steel bridges?

The Environment Agency
The Highways Agency
Network Rail
The Local Authority

When should coating inspection be carried out?

After the job is completed
Only when painting is being carried out
Throughout the whole job
Only for special structures

The design detailing of a steel structure is important for?

Aesthetic purposes
To prevent water and dirt retention
To aid the application of protective coatings
Coating inspection

The corrosion of steel can be controlled by?

Coupling to a more noble metal
Paint coatings
Metal coatings
Washing with chlorinated water

In which 'Corrosivity Category' can steel be used without corrosion protection?

C1
C2
C3
C4