Worked examples to EC3 quiz

From SteelConstruction.info
Revision as of 12:11, 12 March 2019 by Chris.dolling@steelconstruction.org (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Please answer the following 10 multiple choice questions, then click 'submit' to check the result. The pass mark for a CPD certificate is 8 out of 10, and you may retake the quiz as many times as you wish, but the questions will vary! Please note that one, two, three or all of the possible answers presented for each question may be right, and to gain a mark for that question all correct answers must be identified.

Good luck

Worked examples to EC3

In expressions 6.61 and 6.62, what structural mechanics do the k factors account for?

The residual stresses in the member
The shape of the bending moment diagram
The influence of the axial load
The section shape

Which partial factor should be used when calculating buckling resistance?

γM0
γM1
γM2
It depends on the mode of buckling

When is the factor αLT used?

When calculating flexural buckling resistance
When calculating lateral-torsional buckling resistance
When classifying webs subject to axial load and bending
When calculating torsional buckling resistance

When designing, which country's National Annex should be used?

No NA is needed if the recommended values are chosen
The NA for the country where design is carried out
The NA for the country where construction is to be carried out
The choice of NA should be specified by the client

In flexural buckling, what non-dimensional slenderness is approximately equivalent to a slenderness L/ryy = 160?

1.0
2.0
3.0
4.0

Why does torsional-flexural buckling not apply to UKC sections?

It does, but it's never critical
Because UKC sections have a high torsional rigidity
Because the flanges are relatively thick
Because UKC sections are not asymmetric

When calculating the cross-sectional resistance of a member, what is the value of the partial factor, γM0 specified in the UK National Annex?

1.0
1.05
1.1
1.15

For designs to be constructed in the UK, where should the steel strength be taken from?

The designer may choose
The UK National Annex to BS EN 1993-1-1
The product Standard
BS EN 1993-1-1

Which bending modulus should be used with a Class 2 section?

Elastic modulus
Plastic Modulus
Effective Modulus
Young's Modulus

Where does a designer find values of C1 for different shapes of bending moment diagram?

In BS EN 1993-1-1
In the UK National Annex to BS EN 1993-1-1
In NCCI
In an appendix to BS EN 1993-1-1