Acoustics quiz

Please answer the following 10 multiple choice questions, then click 'submit' to check the result. The pass mark for a CPD certificate is 8 out of 10, and you may retake the quiz as many times as you wish, but the questions will vary! Please note that one, two, three or all of the possible answers presented for each question may be right, and to gain a mark for that question all correct answers must be identified.

Good luck

Acoustics

For demonstrating compliance with the acoustic regulations which of these statements is correct?

Robust Details must be used for construction of new dwellings
Dwellings must either be constructed using Robust Details or on-site acoustic testing must be carried out
A qualified acoustic engineer must assess the details used for constructing dwellings
All dwellings must undergo on-site acoustic testing

There are many proprietary acoustic products available, which of these statements is true?

The performance of products can vary significantly even though the products may appear to be similar
Acoustic vinyl flooring is good for impact sound because it addresses the issue at source
Standard office ceiling tiles help significantly with airborne sound insulation
Floor treatment systems all provide a similar improvement in sound insulation

Which of these statements is correct?

It is generally easier to provide sound insulation for high frequency sound
It is generally easier to provide sound insulation for low frequency sound
Sound insulation materials have the same effect on high frequency and low frequency sound
Sound insulation is only required for low frequency sound

In England and Wales the airborne sound requirement for a separating wall between purpose built dwellings is ...?

DnT,w + Ctr ≥ 40 dB
DnT,w + Ctr ≤ 45 dB
DnT,w + Ctr ≥ 45 dB
DnT,w + Ctr ≤ 40 dB

Application of the mass law shows that ...?

2 times the mass gives approximately 10 dB increase in sound insulation
3 times the mass gives approximately 5 dB increase in sound insulation
2 times the mass gives approximately 5 dB increase in sound insulation
3 times the mass gives approximately 12 dB increase in sound insulation

Acoustic insulation testing is generally carried out at ...?

One single frequency
A range of frequencies from 100 Hz to 3150 Hz
Two specific frequencies of 100 Hz and 3150 Hz
A range of frequencies from 300 Hz to 1000 Hz

For separating floors between dwellings which of these statements are true?

Separating floors must include structural concrete
The ceiling part of the floor can have a significant effect on the acoustic performance
The floor treatment applied is usually insignificant to the acoustic performance
There is a wide range of separating floor solutions that can be used in steel framed buildings

Which of the following design approaches should be applied for good acoustic performance?

Concentrate on reducing direct sound transmission rather than flanking sound transmission
Focus on reducing flanking sound as well as direct sound transmission
Apply the combined principles of mass, isolation and sealing
Concentrate on maximising mass to improve sound insulation

In England and Wales the impact sound requirement for a separating floor between purpose built dwellings is ...?

L'nT,w < 52 dB
L'nT,w > 62 dB
L'nT,w > 52 dB
L'nT,w < 62 dB

Impact sound insulation is generally important for what?

Floors only
Walls only
Floors and walls
Neither walls nor floors