Sustainability and steel construction quiz

From SteelConstruction.info

Please answer the following 10 multiple choice questions, then click 'submit' to check the result. The pass mark for a CPD certificate is 8 out of 10, and you may retake the quiz as many times as you wish, but the questions will vary! Please note that one, two, three or all of the possible answers presented for each question may be right, and to gain a mark for that question all correct answers must be identified.

Good luck

Sustainability and steel construction

What is the 2050 UK national reduction target (relative to 1990) for greenhouse gas emissions?

80%
60%
40%
25%

Based on the Target Zero findings, what is the approximate cost (in terms of % of capital cost) to achieve a BREEAM ‘Excellent’ rating for a commercial office building?

0.5%
0.8%
1.5%
5%

What is the current cost per tonne for UK landfill tax for non-hazardous waste?

£8
£24
£32
£64

When assessing the environmental impact of buildings or construction products, what scope of assessment should be used to obtain the most accurate results?

Cradle to gate
Cradle to grave
Cradle to gate with options
It makes no difference

Of these following common construction materials, which has the best end-of-life recycling credentials?

Concrete
Steel
Timber
They are all the same

In England and Wales, which Approved Document is applicable to the operational energy/carbon performance new build, non-domestic buildings?

Approved Document L1A
Approved Document L1B
Approved Document L2A
Approved Document L2B

What are the estimated annual arisings from construction, demolition and excavation activities in the UK?

40 million tonnes
80 million tonnes
120 million tonnes
150 million tonnes

New, non-domestic buildings in the UK will need to be ‘zero carbon’ in operation by?

2013
2016
2019
2050

Which phase of the building life cycle is currently responsible for the greatest proportion of carbon emissions?

Design
Construction
In-use
Demolition

What is the combined reuse and recycling rate for UK structural steel sections?

69%
79%
89%
99%