Introduction to EC3 quiz

Please answer the following 10 multiple choice questions, then click 'submit' to check the result. The pass mark for a CPD certificate is 8 out of 10, and you may retake the quiz as many times as you wish, but the questions will vary! Please note that one, two, three or all of the possible answers presented for each question may be right, and to gain a mark for that question all correct answers must be identified.

Good luck

Introduction to EC3

What value of ξ is specified in the UK National Annex?

The recommended value of 0.85
0.925
0.950
0.875

Must all connections be classified by calculation?

No, classification by experience of satisfactory performance is permitted
Only for elastic design
Only for plastic design
Only if being used outside the UK

In expressions 6.61 and 6.62, what structural mechanics do the k factors account for?

The residual stresses in the member
The shape of the bending moment diagram
The influence of the axial load
The section shape

When would a designer need to refer to BS EN 1993-1-5 and its UK National Annex?

When determining snow loads
When calculating the resistance of the webs of rolled sections
When selecting a steel sub-grade
For design guidance on stainless steel

When can the Eurocodes be used?

When Approved Document A in the Building Regulations is revised
Only when the client specifies design to the Eurocodes
Immediately
Only for projects outside the UK

If a web is Class 3 and a flange is Class 1, what Class is the section?

There must be some mistake; both elements should be the same Class
Class 1
Class 2
Class 3

When determining ULS loads to the Eurocodes, which statements are true?

Wind loads are likely to increase, compared to previous British Standards
Gravity loads are likely to increase, compared to previous British Standards
Calculations using 6.10 will be conservative, compared to the use of both 6.10a and 6.10b
The UK NA simply adopts the recommended values for load factors and combination factors

What best describes a 'destabilising' load?

One applied between restraints
A load applied to the top flange
A load which is free to move laterally with the buckling flange
A non-vertical load, with a lateral component

What structural mechanics is allowed for in the C1 factor when calculating Mcr?

The influence of the axial load
The influence of residual stresses
The shape of the bending moment diagram
Initial imperfections in the member

When calculating the buckling resistance of a member what is the value of the partial factor, γM1 specified in the UK National Annex?

1.0
1.05
1.1
1.15